Trumpet Fingering Chart. All you have to do is play a C# with the 1-2-3 combination and you’ll remember how hard it can be to keep certain valve combinations in tune. Here’s a fingering chart that is very helpful for trombonists switching from trumpet.

In each measure you will see what the notes look like for every valve. Please find the key below to help you understand the fingering chart, I know the valves are being the played with the wrong hand but this has been done to show the valve combinations clearly.

The first valve lengthens the trumpet's tube by 160 mm, the second by 70 mm, and the third by 270 mm. If you want a trumpet that plays well, you need to pay attention to valve alignment. 1st and 3rd Valves .

Playing the trumpet to create some nice tones would require some combinations – pressing one valve at a time might not produce some tones that you might require. Adding extra weight on valve block bottom change instrument resonance, makes brass more stretchy which improve instrument's tone, sound shades, response and general feelings. Piston valves are the stem-like valves with a button-like cap on top.The three valve system had a big flaw, though—as players used more valves in combination, the pitch went continuously sharp. TRUMPET NOTES – VALVE COMBINATIONS. 1st Valve .

The structure of the trumpet enables the note to be lowered by one tone by pressing the first valve, by a semitone by pressing the second valve, and by one and a half tones by pressing the third valve. 2nd and 3rd Valves . How trumpet valve combinations.

Print this out and keep it in your band folder!

No Valves . The natural tendencies of the trumpet, taking into account the most common valve combinations used and overtones based on those valve combinations, make the notes shown below naturally out of tune.

The first trumpe ts TRUMPET NOTES – VALVE COMBINATIONS. The various valve combinations, which substitute for the tuning crooks of the natural trumpet, allow the modern player to "crook" the instrument from F down to B natural; pulling out the tuning and valve slides easily allow playing in B b as well. These valve combinations require a degree of fingering exercises, and you are advised to start one as soon as possible. To make up for that, we can achieve the same effect — three half steps down — by pressing the first and second valves simulteniously. Each measure corresponds to a valve combination.

Valve combinations . Notes can be fine-tuned by using the 1st and 3rd valve slides or … It shows underneath each trombone position what the Euphonium (and trumpet) valve combination is for each concert pitch. The low C# and D are slightly sharp, so they require you to extend the 3rd valve slide by about an inch. The third valve alone is not a commonly used valve combination. All Valves . There are also alternative fingerings possible that teachers or experienced players may recommend to help with intonation and tuning ; … Just like before, the valve numbers are in parenthesis.